Solution

Clients often come to us with just an idea and let us help design models and CNC parts.Usually, when we receive such an inquiry, we will assign it to our corresponding engineer as soon as possible.
Our engineer will start from the design draft of the part, the processing technology required, the surface treatment of the part, and the selection of the material for the machined part. And we will communicate and discuss with our customers one by one.
Ultimately provide the optimal solution for our customer’s machined parts.

Advantages：

More than ten years of engineering experience Excellent team of engineers 7*24 Online service

Situation 1：The Surface Finish Is Poor.

Fault cause: The tip of the tool is damaged, not sharp; Machine tool resonance and placement is not stable; The machine tool crawls; The processing technology is not good.Solution:①Tool wear or damage is not sharp, then re-sharpen the knife or choose a better...

Situation 2：In Batch Production, Workpiece Out-Of-Tolerance Occasionally Occurs.

Cause of failure: must carefully check the fixture, and take into account the operator’s operation method, and the reliability of clamping, due to the size change caused by clamping, must improve the fixture so that workers as far as possible to avoid human...

Situation 3：Processing Plane Is Not Smooth.

Causes of failure: The performance of the finishing cutting oil cannot meet the processing requirements, the tool feed speed is too fast, causing the vibration tool to leave an uneven path on the workpiece surface, and the cutting direction of the tool is...

Situation 4：Tool Change Marks During Fine Milling.

Cause of failure: The traces that appear when the parameters are adjusted without paying attention to the tool change operation.Solution:Replace the small tool for the finishing of the concave corner, carry out and adjust the parameters accordingly.

Situation 5：Burrs And Drapes Left On The Surface Or Sides After Finishing.

Cause of failure: Caused by tool wear or thermal effect.Solution:①Regularly check the wear degree of the tool to ensure that the tool is sharp for cutting.②Do a good job in the planning of the tool path, first machine the surface, then machine the side...

Situation 6：Aperture Reduction or Increase.

Reasons for shrinkage:①Too low cutting speed.②Too large feed.③Too small main declination angle of reamer.④Inappropriate selection of cutting fluid.⑤When sharpening, the worn part of the reamer is not worn off, and the elastic recovery reduces the aperture...